Abicor Binzel ABITIG WH Serie Betriebsanleitung Seite 28

6 Putting into operation
1
5
1 Torch body
2 Gas nozzle
Fig. 2 Equipping the torch
6.1.1 Equipping TIG welding torches 200WS and 400WS
6.2 Tungsten electrode
EN - 10
Equip the torch neck according to one of the following figures:
Step 1 Step 2-3
4
3 Tungsten electrode
4 Torch cap
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder from the front.
3 Hold the tungsten electrode (3) and the electrode holder and
screw on torch cap (4).
4 Screw gas nozzle (2) onto torch body (1).
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder from the front.
3 Hold the tungsten electrode (3) and the electrode holder and tighten the
clamping element using a torque wrench.
 Tab. 10 Tightening torques on page EN-10.
4 Screw on torch cap (4).
5 Screw gas nozzle (2) onto torch body (1).
®
ABITIG WH 220WS
®
ABITIG WH 400WS
Tab. 10 Tightening torques
The electrode type is set by EN ISO 6848. The max. length of electrode
depends on the type of torch.
 2.3 Technical Data on page EN-4
Step 4
3
5 Electrode holder
max. 1 Nm
max. 1.5 Nm
®
ABITIG WH
2