Abicor Binzel ABITIG WH Serie Betriebsanleitung Seite 29

®
ABITIG WH
6.3 Connecting the TIG welding torch
6.4 Mounting the TIG welding torch system on the robot
1 Torch clamp
2 Screw
3 Insulating jacket
Fig. 3 Mounting the TIG welding torch system on the robot
NOTE
• The welding performance is affected by the selection of the tungsten
electrode and by wear. A smooth, groove-free sharpened end of the
tungsten electrode has a positive effect on the welding result.
1 Plug the cable assembly connection into the power supply and secure it with
a connection nut.
1
7
4 Screw
5 ABICOR BINZEL CAT torch
mount
1 Fasten the torch clamp (1) on the cylindrical shaft end of the insulating
jacket (3) with the screw (2).
2 Mount the torch clamp (1) with the screw (4), the disc (6) and the nut (7)
to the ABICOR BINZEL CAT torch mount (5).
For proper mounting of the CAT ABICOR BINZEL torch mount, please
observe the relevant operating instructions.
2
6
6
7
6 Putting into operation
3
4
5
Disc
Nut
EN - 11