Subcode - Radioddity GD-73E Benutzerhandbuch

English user manual - Radioddity GD-73
3. Use the and

selection by pressing the
4. Then use the

of the groups previously defined by the CPS and confirm the selection as
usual with the MENU
5. Finally press ESC
about 10 seconds.
Note
Selecting "Not Match" means a transmission can be received without it's talk group
being programmed in to a GroupList.
SQ
The squelch level is used to filter out weak analogue signals or analogue channels
with strong background noise. This setting, with values ​ ​ from 0 to 9, determines
the signal strength at which the received signal is heard through the speaker. Weaker
signals can be heard at lower settings, while higher settings require progressively
stronger signals in order to be heard. The default setting for squelch is 3. The lowest
setting of "0" disables the squelch completely. As a result, regardless of the selected
analogue channel, you would hear noise from the speaker even when there are no
transmissions on the channel. In contrast, "9" is the highest level and only very strong
nearby transmissions will be heard.
In the function menu:
1. Press the MENU
to select the "Settings" sub-menu and confirm your selection by pressing the
MENU button.
2. Use the and

selection by pressing the
3. Use the and

pressing the MENU
4. Then use the

confirm the selection as usual with the
5. "OK!" Appears briefly on the display before returning automatically to the main
display.
Note
Squelch setting is only applicable to analogue channels

SubCode

CTCSS / DCS is a type of signalling using very low frequency tones (called sub
audible tones). When CTCSS / DCS is set, you will only hear signals that are being
transmitted with the same CTCSS / DCS setting. This prevents you from hearing
unwanted signals on the same frequency. If CTCSS / DCS is switched off, however,
buttons to select the option "GroupList" and confirm

MENU button again.
and keys to select between "None", "Not Match" and one

key.
button several times to return to the main display, or wait
key to enter the function menu, then use the
buttons to select the sub-menu "Channel" and confirm

MENU button again.
buttons to select the option "SQ" and confirm selection by

button again.
and keys to select squelch values between "0" and "9" and

MENU
or
 
key.
Page 30 of 56
v1.0
buttons