Address Setting Doorguard Hardwired Version; Address Setting 16 Dg Disable And Display Module (Item No. 012542.17); Configuration Example I - Honeywell 041460.17 Montage- Und Bedienungsanleitung

Mounting and Operating Instructions Doorguard hardwired version
DIP switch 8 OFF = Slave
ON = Master
(see example 3.4.3)
3.4.2 Address setting - 16-DG disable and display module (Item no. 012542.17 and 012548.17)
Switches
The address "0" is always
DIP switches
S1 to S6 in programmed at the 16-DG
disable and display module
disable and
display
module
Red flashing LEDs at the operating module indicate that users do not exist or that user addresses are
incorrectly set.
3.4.3

Configuration example I

Example for a configuration in the event of networking with 5 Doorguard hardwired versions and a 16-DG disable
and display module (Item no. 012542.17).
The networked Doorguard hardwired version devices with the
address one (1) to fifteen (1111) are programmed as a slave.
One of the networked Doorguard hardwired version device is defined
as a Master. This device coordinates the data of the interconnected
devices.
Setting Master address:
The highest allocated slave address is set at this master Doorguard
device. That means, this address is allocated two times - as slave
address and as master address.
DIP switches in 16-DG display module
31