Overview Operating Unit - Housing Base; Tear-Off Contact; Pull Relief; Solder Bridge - Function - Honeywell 041460.17 Montage- Und Bedienungsanleitung

Mounting and Operating Instructions Doorguard hardwired version
2.2 Overview - operating unit - housing base
Danger: Attention: 230 V AC mains voltage!
Switch off mains voltage before removing
the housing cover!
2.2.1

Tear-off contact

Screw the tear-off contact (eye with lead) directly to the
mounting surface using the enclosed screw and spacer
sleeve. Dowels may be necessary, depending on the
mounting surface.
2.2.2 Pull-relief
Use a cable binder to attach the connecting cables to the

pull relief.

Observe the information on the mains supply in
Chapter 5.1.
2.2.3 Solder bridge - function (from V02.xx)
- Solder bridge open:
- Solder bridge closed:
2.2.4

Installation version 1 - lock cover

A lock cover is included in the scope of delivery. If only an external
operating unit (e.g. key-operated switch) is used to operate the
hardwired version of the Doorguard hardwired version, press the lock
cover onto the front of the housing cover of the operating unit.
Remove the retaining clip (see Fig. above) on the operating
switch!
2.2.5

Installation version 2 - half cylinder

The half cylinder is not included in the scope of delivery.
Due to the constructional differences of half cylinders produced by
various manufacturers, the locking cylinder must be carefully
selected. The length A (see drawing) should be 30 mm. The
housing cover is designed for the length A = 30 mm (optional max.
35 mm). We recommend the use of the half cylinder Item no.
028032.
Acoustical and optical alarms are stopped in two separate operating steps
Acoustical and optical alarms are stopped in one common operating step
27