Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting and Connection Instructions Sounder/Flasher with 2 Inputs BUS-2
5.
Operating modes
The type of module is selected via a solder bridge (see Chapter 6.2).
The set type of module is automatically identified when establishing the connected BUS-2 users.
5.1
Operation as Sounder/Flasher with 2 Inputs BUS-2
Conditions: MB-Secure (from V02)
- The function of the alarm devices and the detector groups is defined via control panel program-
ming.
- Firmware update via BUS-2.
5.2
Operation as 5 Output Module
Operation mode MB12/24/48/100/256
Detector group inputs are not supported
The alarm devices are always activated from the control panel via the BUS-2.
- Tamper monitoring
The cover contact is automatically allocated to the main zone to which the module was allocated.
If the cover contact is triggered, a tamper alarm is signalized in the corresponding zone.
If the module was not allocated to a zone, there is
gered.
Output function
(these parameters can not be changed.)
Output
Function
1
optical signal
2
acoustical signal
3
optical signal
4
optical signal
5
acoustical signal
6.
Programming
The DIP switches are only queried during initialization (when the operating voltage is
applied). Therefore, the setting of this switch is only effective
6.1
BUS-2 address setting
The DIP switches S1/1 to S1/6 serve as coding for the BUS-2
user address. The illustration above, shows the position and
valence of the switches.
In the event of several users,
own
address.
Permissible address range:
in this operating mode!
impulse 1 Hz, low brightness
i
ntervall 2 Hz
impulse 0.5 Hz, medium brightness
static on, max. brightness
static on, max. loudness
each
user must be assigned its
1 to 63.
no
tamper alarm when the cover contact is trig-
, max. loudness
ON
ON
1 2 3 4 5 6
Valence:
1 2 4 8 16 32
when energized
!
Address BUS-2
13
Werbung
Kapitel
Inhaltsverzeichnis
