Maintenance - Wolf Garten GT 830 Gebrauchsanweisung

Operation
Note: Residual current protection
device
These protection devices safeguard while
touching damaged wires, from insulation
flaws and in certain cases, also while
damaging live wires.
• We recommend that the equipment
only be plugged into a power socket,
which is protected by a residual current
protection device (RCD) with a residual
current of not more than 30 m .
• Retrofit kits are available for old
installations. Consult an electrician.
Working position C
The optimal operational gradient for edging
and free-cutting is approx. 30°. For free
cutting (no ground contact) swing device in
a semicircle before your body.
Vertical edge-trimming D E
Teh machine can be adjusted for vertical
trimming. Grip machine firmly. Pull tube
and turn 180° until it audibly engages.

Maintenance

Replacing thread cartridge
Cutting tool coasts to stop!
Disconnect plug before any
maintenance work on the tool!
1. Hold spool case, turn cover in „ UF"
(open) direction of the arrow and remove
it, remove empty thread cartridge
2. Insert the thread end of the new thread
cartridge through the thread lug
Do not loosen the thread from the
retainingslot of the thread cartridge
(2).
On / off switch F
Thread adjustment G
The thread is adjusted with the tilt switch.
Briefly tilt the running machine on a firm
base, e. g. paving slab (approx. 3 kg
pressure). pprox. 2,5 cm cutting thread are
the automatically paid out..
Trimming hints
• Cut tall grass in stages and move the
trimmer slowly.
• Move trimming head only as close to
tree trunks and bushes as necessary.
• Trimming too closely along walls or concrete
slabs wears out line unnecessarily.
• The life of your trimmer will be prolonged
if you clean the ventilating slits before or
after each trimming session and remove
any remaining grass from the bottom of
the device.
D
.
3. Slide thread cartridge over the metal
knob. Pull end of thread until the thread
is loosened from the retaining slot of the
thread cartridge
position of the thread from the thread
cartridge to the thread lug.
4. ttach cover. One of the two arrow
H
markings should point towards the
.
thread lug. Press down on cover and
turn to the right until it catches audibly
J
(1).
L
J
K
. Ensure correct
(1) +(2).
When switched on, thread is cut off
to operational length. Only switch
machine on when in operational
position.
15