Maintenance; Faults And How To Remedy - Wolf Garten RQ 250 Gebrauchsanweisung

GB

Maintenance

6
8
GB

Faults and how to remedy

Please observe safety hints on pages 14–15. Unplug unit from mains before proceeding.
Fault:
Tilt switch does
not function.
Attention: All other problems should be dealt with by an authorized Service Centre.
7
D
9
Reasons:
Thread is jammed.
Spool is empty.
Teeth between metal knob and thread
spool dirty.
Line is torn and stuck inside spool.
Line is „welded" to itself or to spool
through heat build-up.
E
F
G
Remedy:
Pulling the thread out manually.
Press metal button and pull thread at
same time.
Fit new spool).
Clean parts with a brush.
Remove spool, check tightness of win-
ding and replace spool in the usual way.
Remove welded line section, check
tightness of winding and replace spool
in the usual way.
22
Replacing the spool
Grip spool housing firmly. Open lid
(D) in direction of arrow, and re-
move. Remove empty spool from
housing with a slight turn to left
(diag. 6).
Spool RQ-FA
Insert the thread end of the new
spool (E) through the thread lug (F)
(diag. 7); do not loosen the thread
from the retaining slot of the spool.
Slide spool (E) over the metal
knob. Pull end of thread until the
thread is loosened from the retai-
ning slot of the spool (diag. 8).
Ensure correct position of the
thread from the spool to the thread
lug.
Attach cover (diag. 9). One of the
two arrow markings (G) should
point towards the thread lug. Press
down on cover and turn to the right
until it catches audibly.
Attention! When switched on,
thread is cut off to operational
length. Only switch machine on
when in operational position.