Maintenance - Wolf Garten LI-ION POWER GT 815 Gebrauchsanweisung

Operation
use, i.e. before storing the shears away
in autumn.
• The charging time is 4 hours for a battery
that is completely empty.
• The lithium-ion rechargeable battery
can be charged at any charge level and
charging can be interrupted at any time
without damaging the battery (no memory
effect)
Settings
The lawn trimmer is equipped with a four-
position adjustable working angle. This ena-
bles you to easily trim hard-to-reach areas in
your garden.
To set the ideal working position, please fol-
low the instructions below.
1 The cutting head should be inclined
slightly forward while trimming.
Working angle
• Free trimming
Working angle 1 + 2 A
During free trimming, you should swing
the trimmer in a semi-circular motion in
front of your body.
- Set working angle G .
• Trimming under bushes / on slopes
Working angle 3 B
- Set working angle G .
• Edge function (horizontal cut)
Working angle 4 C
The edge function enables precise and con-
venient trimming along the edge of the lawn.

Maintenance

Replacing the cord spool
1 The trimmer continues to spin after being
switched off! Always remove battery before
performing any work on the trimmer!
1. Hold spool case, turn cover in „AUF"
(open) direction of the arrow and remove
it, remove empty thread cartridge M .
2. Insert the thread end of the new thread
cartridge through the thread lug N (1).
3 Do not loosen the thread from the
retainingslot of the thread cartridge N (2).
3. Slide thread cartridge over the metal
1. Turn cutting head 90° H .
2. Set handle angle G .
Telescoping handle and grip
The trimmer is adjusted to your body
height by means of the telescoping han-
dle and the middle grip J K .
Plant hoop guard
The plant hoop guard protects bushes,
trees and plants L (1).
When edging, the plant hoop guard must
remain in the position illustrated in L (2).
On / off switch
Thread adjustment
The thread is adjusted with the tilt switch.
Briefly tilt the running machine on a firm
base, e. g. paving slab (approx. 3 kg pres-
sure). Approx. 2,5 cm cutting thread are the
automatically paid out.
Tips on trimming
• Cut high grass slowly, step by step.
• You can prolong the life of your trimmer by
removing grass from the ventilation slots
and the bottom of the trimmer before or
after each use.
• In order to take full advantage of the bat-
tery capacity, you should not switch the
trimmer on and off unnecessarily.
knob O . Pull end of thread until the
thread is loosened from the retaining slot
of the thread cartridge.
3 Ensure correct position of the thread from
the thread cartridge to the thread lug.
4. Attach cover. One of the two arrow
markings should point towards the thread
lug P (1). Press down on cover and
turn to the right until it catches audibly
P (2).
1 When switched on, thread is cut off to
operational length. Only switch machine
on when in operational position.
F (2)
L (3)
15