Maintenance - Wolf Garten GT 815 AC Gebrauchsanweisung

Operation
Settings
The lawn trimmer is equipped with a four-
position adjustable working angle. This
enables you to easily trim hard-to-reach
areas in your garden.
To set the ideal working position, please
follow the instructions below.
The cutting head should be inclined
slightly forward while trimming.
Working angle and wheels
• Free trimming
Working angle 1 + 2
During free trimming, you should swing
the trimmer in a semi-circular motion in
front of your body.
- Set working angle G .
• Trimming under bushes / on slopes
Working angle 3 B
- Set working angle G .
• Edge function (horizontal cut)
Working angle 4 C
The edge function enables precise and con-
venient trimming along the edge of the lawn.
1. Turn cutting head 90° H .
2. Set handle angle G .

Maintenance

Replacing the cord spool
The trimmer continues to spin after being
switched off! lways remove battery before
performing any work on the trimmer!
1. Hold spool case, turn cover in „ UF"
(open) direction of the arrow and remove
it, remove empty thread cartridge M .
2. Insert the thread end of the new thread
cartridge through the thread lug N (1).
3 Do not loosen the thread from the
retainingslot of the thread cartridge N (2).
Telescoping handle and grip
The trimmer is adjusted to your body
height by means of the telescoping han-
dle and the middle grip J K .
Plant hoop guard
The plant hoop guard protects bushes,
trees and plants L (1).
When edging, the plant hoop guard must
remain in the position illustrated in L (2).
On / off switch
Thread adjustment
The thread is adjusted with the tilt switch.
Briefly tilt the running machine on a firm
base, e. g. paving slab (approx. 3 kg
pressure). pprox. 2,5 cm cutting thread
are the automatically paid out.
Tips on trimming
• Cut high grass slowly, step by step.
• You can prolong the life of your trimmer
by removing grass from the ventilation
slots and the bottom of the trimmer be-
fore or after each use.
• In order to take full advantage of the bat-
tery capacity, you should not switch the
trimmer on and off unnecessarily.
3. Slide thread cartridge over the metal
knob O . Pull end of thread until the
thread is loosened from the retaining slot
of the thread cartridge.
3 Ensure correct position of the thread from
the thread cartridge to the thread lug.
4. ttach cover. One of the two arrow
markings should point towards the thread
lug P (1). Press down on cover and
turn to the right until it catches audibly
P (2).
When switched on, thread is cut off to
operational length. Only switch machine
on when in operational position.
F (2)
L (3)
15