Nice Neomat T Installation Seite 3

Without FRT
2) Installation
Incorrect installation could cause serious injury.
Proceed as follows to prepare the motor:
1. Position the limit switch crown (E) on the motor (A) until it fits into
the corresponding limit switch ring (F); make sure that the two
grooves match. Push it into position as shown in Fig. 5.
2. Mount the drive wheel (D) on the motor shaft.
3. On NEOMAT-MT fasten the drive wheel with the snap ring. On
NEOMAT-LT fasten the drive wheel with the M12 nut and washer.
4. Fit the assembled motor into the winding roller until the crown (E) is fully inserted. Fasten the drive wheel (D) to the winding roller using
the M4x10 screw, so as to prevent the motor from slipping or sliding axially (fig. 6).
5. Finally, secure the motor head to the special support (C) with the spacer (if any), using the clips or split pin (B).
2.1) Electrical connections
For motor connections, an omnipolar disconnecting
device with a 3-mm minimum distance between contacts
must be provided for disconnection from the mains power
supply (disconnecting switch or plug and socket, etc.).
Carefully follow all the connection instructions, if you
have any doubts do not make experiments but consult the
relevant technical specifications sheets which are also
available on the web site www.niceforyou.com.
An incorrect connection may be dangerous and cause
damage to the system.
Yellow label
Violet label
With FRT
A: NEOMAT-T Tubular motor
B: Fastening clips or split pins
C: Support and spacer
D: Draw lock ring
E: Idle lock ring
F: Idle ring
The cable used for the electrical connections of the NEOMAT-MT
and NEOMAT-LT motors has 6 wires; 3 of the wires (yellow tag) are
for the mains power supply and 3 wires (violet tag) are for the com-
mand signals.
For the electrical connections see the diagram below. The connec-
tion devices are not supplied with the product.
L
N
Wire colouring:
Mains power supply
Brown
Blue
Yellow/Green
Command signals
Black/White
Orange/White = Weather sensors
Arbour awning with hooks
= Phase
= Neutral
= Earth
= Common (0V) White
= Step-by-St. + "TTBUS" or
F210S
GB
3