Second Master Card - Telecom Behnke myintercom Plus Anleitung

Hold the master card in front of the card
reader again, while the display flashes. The
displayed time is programmed and the right-
hand decimal point is lit.
The master card can now be removed. The
display goes out.
www.behnke-online.de
myintercom Plus IP video door intercom Instructions

4.4. Second master card

Programming a second master card
To ensure maximum security, the factory
master card can only be programmed by
Telecom Behnke GmbH. Therefore, it should
always be kept in a secure place.
In addition to the factory master card, it is
possible to approve another transponder as a
2nd master card. To do this, you will need the
factory master card supplied.
Hold the factory master card in front of
the card reader. The memory locations are
counted off up to 190 ("
display then appears:
Remove the factory master card from the card
reader. The display lights up continuously
for approx. 3 seconds and then flashes for
approx. 6 seconds. Hold the transponder,
which is to be used as the 2nd master card, in
front of the card reader.
The new transponder is now programmed as
the 2nd master card and the right-hand deci-
mal point lights up.
Card reader
"). The following
1.9
GB
63