Addressing; Connection With The Mains; Operation; Stand Alone Operation - EuroLite SL-1200 Bedienungsanleitung

Addressing

Each projector occupies 4 channels. To ensure that the control signals are properly directed to each
projector, the projector requires adressing. This is to be done for every single projector by changing the DIP
switches as set out in this table.
The starting address is defined as the first channel from which the SL-1200 will respond to the controller. If
you set, for example, the address to channel 5, the SL-1200 will use the channel 5 to 8 for control.
Please make sure that you don't have any overlapping channels in order to control each SL-1200 correctly
and independently from any other fixture on the DMX data link. If two, three or more SL-1200 are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Device 1 - channels 1-4
Device 2 - channels 5-8
Device 3 - channels 9-12
Device 4 - channels 13-16
Device 5 - channels 17-20

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the SL-1200 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Move the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the SL-1200 can be used without controller.
Disconnect the SL-1200 from the controller and set all DIP-switches to Off.
1
DIP-switch no.
DMX-starting
1
address
On
Off Off
On
Off
On
Off
On
Off
On
Off
International
L
N
2 3 4 5 6
2 4 8 16 32
23
7 8 9
64 128 256