Qos Rules - Elcon ELCONNECT next BIG 10 Bedienungsanleitung

Figure 13: Processing sequence for the miscellaneous QoS-mechanisms
The BIG 10 consists of four internal queues for each port in order to achieve the optimum
Quality of Service. Packets are classified into each queue depending on their priority. The
unchangeable priorities of the queues are as follows:
The QoS rules of all switch ports described next can be assigned to those queues.

3.8.4 QoS Rules

This chapter defines the rules for classification of incoming data traffic. At the same time the
data will be classified in one of 4 Priority Queues (highest, high, normal, low).
Note In order to be able to apply the QoS-rules at the LAN ports, they have to be confi-
gured in switch mode. For this, see also chapter 3.8.1.
Rx-Port
This site allows you to determine the way how incoming data traffic is classified at the re-
spective Rx-Port (receiver side of the LAN-/WAN-ports). The data are assigned to one of 4
Priority Queues. To enable this rule, it has to be selected in case of need for the respective Rx-
Port in chapter "QoS Settings".
54
Queue Priority
0 low
1 normal
2 high
3 very high
BIG 10 Router
Version: 2011/01/19