BIG 10 Router
SNMP
1.2
General characteristics
• symmetrical data transfer at max. 22 Mbps via standard copper wire pairs
• 2/4 × SHDSL EFM with eSHDSL and EFM-Bonding support
• range extension using up to 4 repeaters or flexible adaptation of the SHDSL bit rate
• calibration of the copper twin wire and specific setup of target noise margins via Line
Probing (PMMS)
• customer interfaces
o 4 × Ethernet
o WLAN 802.11b/g (only order no. 900220)
• switch and router support, support of transparent layer 2 bridging and routing
• operation as NT with third-party DSLAM's
• support of VLAN Tagging for the separation of voice and data services
• traffic shaping and prioritization support for guaranteed high QoS
• support of IPSec pass-through
• local and remote management via GUI; integration in 3
• SNMP v1/v2/v3 support
• local power supply
Version: 2011/01/19
Figure 1: Basic application scenario
rd
-party NMS via SNMP
37