Putting Into Operation; Restart And Factory Reset; Activation / Deactivation Of Wlan (Only Order No. 900220); Maintenance - Elcon ELCONNECT next BIG 10 Bedienungsanleitung

BIG 10 Router
2.6

Putting into operation

After application of the supply voltage and performed self-configuration the BIG 10 is ready
for work. The complete line of the provider network to the BIG 10 will be put into operation
by your operator. It has a preset configuration or makes the required settings automatically by
auto-configuration.
Prerequisite for proper operation of your data link via the BIG 10 is the correct installation of
the network interface card to your PCs. Detailed information on this should be received in the
documentation provided by the card manufacturer. Further questions about configuration of
your PC should be addressed to your Service Provider.
2.7

Restart and Factory Reset

In case you find the BIG 10 in an undefined operating state (e.g. when no data transfer is
possible), press the Reset button on the right side of the casing with a pointed tool (i.e. pen or
paper clip) for a short moment (ca. 1 s). The device will then perform a restart and the data
connection will be established anew. Contact in any case your service provider before. Press-
ing the reset button for more than 5 s will cause a factory reset of the device, whereby all per-
formed settings will be lost. A reset to the default configuration should only be realized by
experienced users. A Factory Reset may result in complete non-functionality of the BIG 10!
Therefore, contact in any case your service provider before!
2.8

Activation / Deactivation of WLAN (only order no. 900220)

Upon initial start-up of the device the WLAN module is deactivated as well. The WLAN
module can be activated by keying the WLAN button placed on the right side of the housing
below the reset button.
By pressing the WLAN button a second time, the WLAN module will be deactivated again.
The current status is indicated through the WLAN status LED.
2.9

Maintenance

Your BIG 10 is maintenance-free. For cleaning please use a dry cloth. Never use aggressive
or caustic detergents.
Before cleaning, remove the power supply unit out of the socket, or put the device
out of operation.

2.10 Uninstallation of the BIG 10

To uninstall the BIG 10, first disconnect all cables, starting with the power supply unit. After
all cables are removed, the device can be taken from the wall.
Version: 2011/01/19
41