Configuration Of The Big10 Router Via Inbuilt Graphical User Interface (Gui) - Elcon ELCONNECT next BIG 10 Bedienungsanleitung

3 Configuration of the BIG10 router via inbuilt graphical user interface
(GUI)
The BIG 10 can easily be configured using its in-built graphical user interface. This can be
done using a standard Internet browser (Firefox, Internet Explorer, Safari), which are availa-
ble at most modern computer today.
To access the Web-GUI proceed as follows:
1. Make sure, that the network settings of your computer allow the automatic IP-address
assignment. Please ask you network administrator for further details.
2. Connect your computer with the LAN interface of the BIG 10 using a standard Ether-
net cable.
3. After connecting the device, the computer will be assigned by an IP-address automati-
cally.
It is as well possible to use a static IP-address. For this apply your computer the following
data:
Address Range
Subnet Mask
Gateway Address
Open now your Web-Browser and type the following in the address field:
http://192.168.1.1
Note Make sure, that your proxy settings are switched off or set correctly.
The following login window appears after successful connect:
42
Pre-Settings
192.168.1.2 bis 255
255.255.255.0
192.168.1.1
Figure 4: Login window
BIG 10 Router
User-Settings
Version: 2011/01/19