Charging - Silvercrest SAS 7.4 LI D3 Bedienungsanleitung

4) Push the wall plugs into the holes and then screw the wall bracket 3 firmly
into place using the screws .
5) You can place the nozzles on the accessories holder on the side .
6) Connect the mains adapter 4 to a mains power socket .

Charging

NOTE
► Check to ensure that the on/off switch 6 has been pushed back (to the
position "0") before starting the charging process .
■ Place the handheld vacuum cleaner from above into the wall bracket 3 so
that the barrel plug 5 slips into the socket on the handheld vacuum cleaner .
The charge indicator lamp 7 lights up red and the charging process begins .
■ Important: The charge indicator lamp 7 lights up green once the
handheld vacuum cleaner is charged enough to vacuum again . This does
not mean that all the batteries are completely charged . When the charge
indicator lamp 7 lights up green, the batteries are charged to around 80% .
■ When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function) . Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter 4 .
■ Do not recharge the batteries again until the handheld vacuum cleaner's suc-
tion power becomes appreciably weaker and the charge indicator
lamp 7 flashes green .
NOTE
► If the battery is completely discharged, the appliance switches off and
the charge indicator lamp 7 flashes green/red alternately for approx .
60 seconds . Start charging the appliance .
► The handheld vacuum cleaner can also be charged directly via the mains
adapter 4 . To do this, remove the barrel plug 5 with a slight twist from
the wall bracket 3 and the cable from the cable routing . Insert the barrel
plug 5 into the socket on the handheld vacuum cleaner .
SAS 7.4 LI D3 GB │ IE │ 25 ■