Service / Maintenance / Repair - Baier BDB 802 Bedienungsanleitung

•
Never use damaged insert tools. Before
each use, check insert tools for splinters
and cracks. If the power tool or insert tool
is dropped or falls, check whether it is dam-
aged, or use an undamaged insert tool. If
you have checked and inserted the insert
tool, keep yourself and other people nearby
outside the plane of the rotating insert tool
and let the power tool run at maximum speed
for one minute.
Most damaged insert tools break during this test
period.
•
Do not expose power tools to extreme heat
or cold.
Mechanical and electrical damage can occur
during extreme heat and/or cold.
•
Allow the insert tools, tool holders and oth-
er parts cool in the immediate vicinity of the
work area after use.
The equipment can be very hot after use. Do not
touch or grip the parts. Risk of injury.
•
Additional signs or other, non BAIER-spe-
cific parts may not be screwed or riveted
onto the motor, handle, gearbox or protec-
tive housing.
This could damage the power tool and cause
malfunctions to occur.
•
When fixing the drill stand on the workpiece
using anchors and screws, ensure that the
anchoring used is able to hold the machine
safely during use.
If the workpiece is not resistant or is porous, the
anchor can be pulled out, which causes the drill
stand to detach from the workpiece.
•
If fixing the drill stand on the workpiece by
means of a vacuum plate, ensure that the
surface is smooth, clean and not porous. Do
not fix the drill stand onto laminated surfac-
es, such as tiles and facings of composite
materials.
If the surface of the workpiece is not smooth, flat
or adequately fixed, the vacuum plate can de-
tach from the workpiece.
NOTE
The above safety instruction only applies if it is
planned to use the tool with a vacuum plate.
•
Before and while drilling, ensure that the
vacuum is sufficient.
If the vacuum is insufficient, the vacuum plate
can detach from the workpiece.
NOTE
The above safety instruction only applies if it is
planned to use the tool with a vacuum plate.
•
Never carry out overhead drilling and drill-
ing in the wall, if the machine is only fixed by
means of a vacuum plate.
In the event of loss of vacuum, the vacuum
plate detaches from the workpiece.
NOTE
The above safety instruction only applies if it is
planned to use the tool with a vacuum plate.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work instruc-
tions for the accessories used.

2.6.6 Service / Maintenance / Repair

•
If the power tool is dropped or becomes wet,
have it checked.
A possibly damaged power tool is dangerous
and no longer safe to operate. Before using the
power tool again, have it checked by our cus-
tomer service or an authorised service centre of
Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised workshop of
Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims
against Maschinenfabrik OTTO BAIER GmbH
expire.
NOTE
If using new carbon brushes, do not overload the
machine during the first 10 minutes of operation.
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised
dealers. Use of non original parts can cause
damage to the machine and an increased risk of
accidents.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair com-
pany authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.
| 33 |