Cycle Description Chart - SciCan HYDRIM M2 G4 Bedienerhandbuch

5. Instructions for Use (cont.)
5.3 HYDRIM M2 G4 Cycle Description Chart
Cycle Prewash
P0 – Machine <30ºC (cold)
3-10 minutes
Cleaning Cycle
(default 3
No initial draining.
minutes)
P1 – Rinse and
Hold Cycle*
<30ºC (cold)
Use to prevent
3-10 minutes
soil from drying on
(default 3
instruments when they
minutes)
will not be washed
within one hour.
P2 – Regular
<30ºC (cold)
Cycle
3-10 minutes
(no disinfection) – Use
(default 3
for moderately soiled
minutes)
loose instruments.
P3 – Heavy Duty
<30ºC (cold)
Cycle
3-10 minutes
Use for heavily soiled
(default 3
instruments and
minutes)
cassettes.
P4 – Custom
<30ºC (cold)
(A between A =
3-10 minutes
0 0
3,500 (rinse) (default 3
minutes)
and A = 6,000)
0
* This is not a wash cycle. Always run a wash cycle following the rinse & hold cycle.
** Cycle times depend on the temperature and pressure of incoming water.
*** Water consumption includes drying phase
The P3 and P4 disinfection temperature reflects the minimum guaranteed temperature
at any time during disinfection anywhere in the wash chamber. However, the disinfection
temperature is set to be around 93°C, with an upper switch point of the heater at 94°C
and a lower switch point of 92°C.
The HYDRIM M2 G4 incorporates a unique design where the air from the dryer motor
is pushed through the wash arms. The wash arms turn during the second high-speed
drying phase. This unique feature allows the HYDRIM M2 G4 to eliminate the risk of
water drops falling onto the dried instruments during unloading.
The disinfection time of P4 can be increased by 1 minute incremental intervals from 1 to
5 minutes. The minimum disinfection time is 1 minute with a minimum A
The minimum A
to be set and validated by a technician after installation in the office.
NOTE: ISO 15883-1 describes the time-temperature relationships for moist heat disinfection as follows:
"For a moist heat disinfection process, a particular time at a particular temperature can be expected to have
a predictable lethal effect against a standardized population of organisms. Definition of moist heat disinfection
process may be achieved by means of the A
process at different temperatures to assess the overall lethality of the cycle and express this as the equivalent
exposure time to a specified temperature."
Intermediate
Wash
Rinse
N/A N/A
N/A N/A
50ºC
<60ºC/140°F
5-15 minutes
1 minute
(default 9
minutes)
50ºC
<60ºC/140°F
5-15 minutes
1 minute
(default 9
minutes)
50ºC
5-15 minutes
N/A
(default 9
minutes)
value for disinfection time of 5 minutes is 6000. The final rinse time has
0
method, which uses knowledge of the lethality of the particular
0
Rinse Dry
<30ºC (cold)
N/A
2 minutes
60ºC
N/A
1 minute
20-60
60ºC
minutes
1-10 minutes
(default 30
(default 1 minute)
minutes)
20-60
90ºC
minutes
5 minutes
(default 30
minutes)
20-60
90°C
minutes
adjust. from
(default 30
1 to 5 minutes
minutes)
12
Total Time **
Water
w/o Drying Consumption
6
16 Ll
minutes
18
16 L
minutes
35
32L
minutes
60
40L***
minutes
40L***
value of 3500.
0