Datalog Deletion Setting - Thermo Scientific Orion Star series Bedienungsanleitung

Data Archival and Retrieval

Datalog Deletion Setting

The datalog deletion setting determines if the meter will automatically delete
the datalog after it is downloaded to a printer or computer and if the meter will
overwrite the datalog points when the datalog is full . If the datalog deletion setting
is set to , the meter will automatically delete the datalog after the datalog
is downloaded to a printer or computer . The meter will also display the
error message when all 200 datalog points are filled and the datalog must be
downloaded to a printer or computer to clear the error message . If the datalog
deletion setting is set to
when all 200 datalog points are filled and will not delete the datalog after the
datalog is downloaded to a printer or computer .
1 . In the measurement mode, press
2 . Press /
3 . Press to accept the selection and move the arrow icon to the middle line
and press
4 . Press to accept the selection and move the arrow icon to the bottom line
and press
5 . Press to accept the selection and move the arrow icon to the top line .
6 . Press to save the setup option and return to measurement mode .
Note: If the datalog is not required, set the datalog deletion setting to
to prevent the error 038 (datalog full) message.
EN-50
, the meter will overwrite the oldest datalog point
until is displayed on top line .
/ until is displayed .
/ until or
Thermo Scientific Orion Star
.
is displayed .
and Star Plus Meter User Guide
™