Maintenance; Cleaning; Wearing Parts; Technical Data - Bosch BSL 2470 Betriebsanleitung

5.

Maintenance

5.1

Cleaning

The charger's housing and display should only be
cleaned using a damp cloth and neutral cleansers.
Do not use any abrasive cleaning detergent nor rough
workshop cloths.
5.2

Wearing parts

Description
Mains cable
Charger cables
!
If the charger cables or mains supply cable have
been damaged they must always be replaced by
original cables; these are available from the after-
sales department of the manufacturer in question.
5.� Disposal
This BSL 24�� is subject to European guideli-
nes 2��2/�6/EG (WEEE).
Old electrical and electronic devices, including-
cables and accessories or batteries must be
disposed of separate to household waste.
¶
Please use the return and collection sys-
tems in place for disposal in your area.
¶
Damage to the environment and hazards to
personal health are prevented by properly
disposing of BSL 2470.
Robert Bosch GmbH
6.
Charge current with 12 Volt / 24 Volt batteries can be
adjusted to any level.
When the control is set to maximum battery charging
current and 230 V mains voltage, the charging currents
will record the following values:
R
In 12 V-mode with 12 V charge voltage the battery
charging current is max. 140 A arithm. and during a
start-assist measure (1 V / cell) the start-assist cur-
rent is max. 250 A arithm.
Order number
R
In 24 V-mode with 24 V charge voltage the battery
1 684 460 276
charging current is max. 88 A arithm. and during a
1 684 461 174
start-assist measure (1 V / cell) the start-assist cur-
rent is max. 220 A arithm.
Description
Charging characteristic
Maximum charge volta-
ge at setting >15 °C
Maximum charge volta-
ge at setting <15 °C
Charger cable 3 m
Function temperature range
Mains rated voltage
Mains rated frequency
Mains fuse system
Power consumption
Battery nominal voltage
Battery capacity
Dimensions (W x H x D)
Weight
Degree of protection (DIN EN 60529)
Protective category (DIN EN 61010-1)
Radio interference suppression
Interference degree of emission I
Workplace related
noise emission value (Lpa)
Maintenance | BSL 24�� | 1� BSL 24�� | 1�

Technical data

1 689 989 004
| 1� en
Specification
WU
2,3 V per cell
2,4 V per cell
16 mm with fully
2
insulated char-
ger terminals
0 °C to 50 °C
230 VAC 10%
50 Hz
H 250 T 15A
2800 W
12 V / 24 V
36 Ah to 400 Ah
400 x 930 x 330 mm
approx. 29 kg
IP 20
I
VDE 0875
DIN 40839 or
ISO 7637 part 1
and part 2
≤ 70 dB(A)
|
2008-06-12