Maintenance And Servicing; Maintenance And Cleaning - Bosch BCS220 Ergänzung Zur Originalbetriebsanleitung

The state of charge is displayed by the battery charge indic-
ator (9) on the battery and by the bars on the on-board com-
puter.
The LEDs on the battery charge indicator (9) flash during the
charging process. Each solid illuminated LED represents ap-
proximately 20 % of the charging capacity. The flashing LED
indicates the next 20 % currently charging.
Once the eBike battery is fully charged, the LEDs go out im-
mediately and the on-board computer is switched off. The
charging process is terminated. The state of charge can be
displayed for 3 seconds by pressing the on/off button (10)
on the eBike battery.
Errors – causes and corrective measures
Cause
Battery defective
Battery too warm or too cold
The charger is not charging.
Charging not possible (no indicator on battery)
Connector not attached properly
Battery contacts dirty
Plug socket, cable or charger defective
Battery defective

Maintenance and servicing

Maintenance and cleaning

If the charger fails, please contact an authorised bike dealer-
ship.
After-sales service and advice on using products
If you have any questions about the eBike system and its
components, contact an authorised bicycle dealer.
For contact details of authorised bike dealerships, please
visit www.bosch-ebike.com.
Disposal
Chargers, accessories and packaging should be recycled in
an environmentally friendly manner.
Do not dispose of chargers along with household waste.
Bosch eBike Systems
Disconnect the charger from the mains and the battery from
the charger.
When the battery is disconnected from the charger, the bat-
tery is automatically switched off.
Note: If you have charged the battery on the bike, carefully
close the charging socket (6) with the cover (7) after char-
ging, so that no dirt or water can get in.
If the charger is not disconnected from the battery after
charging, after a few hours the charger will switch itself back
on, check the state of charge of the battery and begin the
charging procedure again if necessary.
Corrective measures
Two LEDs flash on the battery.
Contact an authorised bike dealership.
Three LEDs flash on the battery.
Disconnect the battery from the charger until the charging
temperature range has been reached.
Do not reconnect the battery to the charger until it has
reached the correct charging temperature.
No LEDs flashing (one or more LEDs will remain perman-
ently lit depending on the state of charge of the eBike bat-
tery).
Contact an authorised bike dealership.
Check all connections.
Carefully clean the battery contacts.
Check the mains voltage, have the charger checked over by a
bike dealership.
Contact an authorised bike dealership.
Check that your personal data has been deleted from the
device.
Only for EU countries:
According to the European Directive 2012/19/
EU on Waste Electrical and Electronic Equip-
ment and its implementation into national law,
chargers that are no longer usable must be col-
lected separately and disposed of in an envir-
onmentally friendly manner.
Please return Bosch eBike components that are no longer
usable free of charge to an authorised bicycle dealer or to a
recycling facility.
Subject to change without notice.
English – 3
0 275 007 XCX | (20.01.2022)