Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION INSTRUCTIONS
3. Use the screws supplied to fasten the positioning plate (A)
against the bottom of the worktop so that the holes are
aligned.
control knob (2x)
(D)
conical spring (2x)
rosette (2x)
screw (4x)
(B)
light ring (2x)
sealing ring (2x)
pin (2x)
(C)
spring (2x)
(A)
positioning plate (1x)
screw (4x)
hole Y
(E)
control box
nut M4 (2x)
4. When mounting the knobs into the worktop the sealing
rings (B) should be mounted underneath the light rings.
5. Place the light rings (B) from the top through the holes in
the worktop and fasten them from the top with the screws
supplied.
6. Place the springs on the pins (C) and push them from the
bottom through the light rings in the worktop.
7. Place the conical springs on the control knobs (D).
EN 30
Top-stone
contents
Werbung
Inhaltsverzeichnis
