Atag TY3011M Anleitung Seite 113

INSTALLATION INSTRUCTIONS
nut M4 (2x)
(E)
control box
hole Y
spring (2x)
(C)
pin (2x)
(A)
positioning plate (1x)
upwards.
4. Remove the protection plate.
5. Screw the positioning plate (A) against the rear of the kitchen
front with the screws supplied. The holes for the control
knobs should be aligned. Use the light rings as fi tting pins.
6. Now press the light rings (B) from the front through the
holes in the kitchen front and screw them tight with the
screws supplied.
7. Place the springs onto the pins (C) and push them from the
rear through the light rings in the kitchen front.
Place the conical springs on the control knobs (D).
The teppan yaki comes with two sets of rosettes. For this
screw (4x)
(B) light ring (2x)
screw (4x)
rosette (2x)
(D)
conical spring (2x)
control knob (2x)
EN 17
contents "Front"