Troubleshooting - Abicor Binzel ABIROB A360 Betriebsanleitung

10 Troubleshooting

10 Troubleshooting
Problem
Torch necks gets hot • Contact tip not tightened
No push-button
function
Wire burned solid in
the contact tip
Irregular wire feed
Arc between gas
nozzle and work-
piece
Unsettled arc
Tab. 8 Troubleshooting
EN - 16
3 Check wearing parts for visible damage and replace them, if required.
4 Replace equipment kit when worn or soiled.
5 Clean separating point and O-rings with silicone-free sealing grease.
6 Check the TCP after each use or after a collision in the WH setup device.
NOTE
• Some problems are listed below, with descriptions of possible causes
and solutions. If the measures described below are not successful, please
consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as power supply, air pressure line.
Cause
• Contact tip loose on the neck side
and toward the work-piece
• Control line interrupted / defective
• Wrong parameters set
• Contact tip worn out
• Guide spiral liner/PA liner clogged
• Contact tip and wire diameter not
matched
• Wrong contact pressure set on the
wire feed unit
• Spatter bridge between contact tip
and gas nozzle
• Contact tip not matched to the wire
diameter or contact tip diameter
enlarged
• Wrong welding parameters set
• Wire guide unit worn-out
Solution
• Check and tighten
• Check and tighten
• Check/repair
• Check or correct setting
• Replace
• Clean both directions with
compressed or replace it, if necessary
• Replace contact tip
• Correct as specified by manufacturer
• Clean and spray gas nozzle interior
• Check contact tip
• Correct welding parameters
• Replace wire guide unit
®
ABIROB A