Connecting An Additional Interface Of The Uc Variants - G&D DP1.2-Vision-Fiber Installation Und Bedienung

Connecting further interfaces of ARU2 variants
USB 2.0 Trans. USB 2.0 CPU
Transmission DP Out DP CPU
Use the USB-AM/BM-2 cable to connect one of the computer's USB
USB 2.0 CPU:
interfaces to this interface.
IMPORTANT: Transmitting data of USB 2.0 devices connected to the USB 2.0 Devices
interface of the user module between the user module and the computer module
(and vice versa) requires transmission modules that use laser technology and com-
ply with laser class 1.
Please note the following safety instructions regarding this matter:
 Only use G&D certified transmission modules on page 3
USB 2.0 Trans.|Tx: Insert the LC plug of a fibre optic cable, which is available as
accessory, into this interface. Connect the other end to the
face of the user module.
Insert the LC plug of another fibre optic cable into this interface.
USB 2.0 Trans.|Rx:
Connect the other end to the
NOTE: Connect the USB 2.0 Trans.
card CCD-IO16-Card-MULTI if you want to connect the computer module to a
compatible matrix switch (see page 5).
Mind the notes in the paragraph Purpose and configuration of multi cards in the user
manual of the web application.

Connecting an additional interface of the UC variants

NOTE:
With the also available
a computer to two different digital extenders of the Vision series.
Alternatively, you can connect a compatible matrix switch to each of the two
channels instead of a digital extender.
Transmission 2
In
Transmission 1 CPU
Keyb./Mouse
In Line Out USB CPU Keyb. CPU
USB 2.0 Trans.|Tx
interfaces to one of the dynamic ports of the IO
UC versions of the target modules, you can connect
Keyb./Mouse
Line Out
DisplayPort 1
Out
RS232
Red. Power
USB 2.0 Trans.|Rx
interface of the user module.
RS232
Red. Power
Keyb. CPU Mouse USB CPU
G&D DP1.2-Vision-Fiber · 10
Installation
inter-