Connecting An Additional Interface Of The Uc Variants - G&D DP1.2-Vision-CAT Installation Und Bedienung

Installation
Connecting further interfaces of ARU2 variants
USB 2.0 Trans.
Transmission DP Out
USB 2.0 CPU: Use the USB-AM/BM-2 cable to connect one of the computer's USB
interfaces to this interface.
USB 2.0 Trans. Plug a category 5e (or better) twisted pair cable, which is available as
accessory, into this interface. Connect the other end of the cable to the
interface of the user module.
NOTE: Connect the
card CCD-IO16-Card-MULTI if you want to connect the computer module to a
compatible matrix switch (see page 4).
Mind the notes in the paragraph Purpose and configuration of multi cards in the user
manual of the web application.

Connecting an additional interface of the UC variants

NOTE: With the also available
a computer to two different digital extenders of the Vision series.
Alternatively, you can connect a compatible matrix switch to each of the two
channels instead of a digital extender.
Transmission 2
Transmission 1 DP Out
Plug a category 5e (or better) twisted pair cable, which is available as
Transmission 2:
accessory, into this interface. Connect the other end of the cable to the respective
interface of a compatible computer module or matrix switch.
9 · G&D DP1.2-Vision-CAT
USB 2.0 CPU
Keyb./Mouse
DP CPU In Line Out USB CPU
USB 2.0 Trans. interface to one of the dynamic ports of the IO
versions of the target modules, you can connect
UC
Keyb./Mouse
DP CPU In Line Out USB CPU
RS232
Keyb. CPU Red. Power
RS232
Keyb. CPU Red. Power
USB 2.0 Trans.