G&D DP1.2-Vision-Fiber Installation Und Bedienung Seite 95

IMPORTANT: Transmitting data of USB devices connected to the user module
between the user module and the computer module (and vice versa) requires trans-
mission modules that use laser technology and comply with laser class 1.
Please note the following safety instructions regarding this matter:
 Only use G&D certified transmission modules on page 3
USB 2.0 Trans.|Tx: When using an
cable connected to the USB 2.0 Trans.|Rx interface of the computer module.
USB 2.0 Trans.|Rx: When using an
cable connected to the USB 2.0 Trans.|Tx interface of the computer module.
NOTE:
Connect the USB 2.0 Trans.
card CCD-IO16-Card-MULTI if you want to connect the computer module to a
compatible matrix switch (see page 5).
Mind the notes in the paragraph Purpose and configuration of multi cards in the user
manual of the web application.
Connecting an additional interface of the CON-2 variants
NOTE:
With the also available
nect a console to two different digital extenders of the Vision series.
Alternatively, you can connect a compatible matrix switch to each of the two
channels instead of a digital extender.
Transmission 2 RS232
Transmission 1 DP Out
IMPORTANT:
The device uses components with laser technology which comply
with laser class 1.
Never stare directly into the beam when wearing optical instruments!
NOTE: Remove the protection caps from the Transmission interfaces and the cable
plugs.
Insert the LC plug of the fibre optic cable connected to the Transmis-
Transmission|Tx:
sion|Rx interface of a compatible computer module or matrix switch.
ARU2 variant, insert the LC plug of the fibre optic
ARU2 variant, insert the LC plug of the fibre optic
interfaces to one of the dynamic ports of the IO
CON-2 versions of the user modules, you can con-
USB Devices Mouse
Generic
Micro In Speaker Keyb./Mouse Keyb. Red. Power
G&D DP1.2-Vision-Fiber · 16
Installation