Resetting The Default Settings - G&D DP1.2-Vision-Fiber Installation Und Bedienung

Resetting the default settings

NOTE: This function can be carried out only via web application.
This function is used to reset the default settings of the KVM extender. By perform-
ing this function, the default settings mentioned on page 25 are reactivated.
How to reset the default settings:
NOTE: Open the local OSD of the user module by pressing the
Alt + Num ) if you want to reset the local settings of the user module only instead of
the settings of the extender system.
1. Open the remote OSD of the computer module by pressing
(default: Ctrl +
Open the local OSD of the user module by pressing the
Alt + Num ) if you want to reset the local settings of the user module.
2. Select the row
(local OSD) and press
3. Select the row
4. Confirm the security prompt or cancel the process.
1. In the menu, click on
2. Click on System defaults
3. Select the scope of the recovery:
Reset all settings
 Reset all settings of the device.
Reset only local network settings
 Reset only local network settings.
Reset only KVM application settings
 Reset all settings except the local network settings.
4. Click on
Set system defaults
NOTE:
You can also reset the default settings by pressing the Reset keys.
Further information about this topic is given on page 23.
Num ) if you want to reset the settings of the extender system.
System setup (remote OSD) or
Enter .
Set system defauts and press
System .
.
.
local hotkey
remote hotkey
local hotkey
Console utility
Enter .
G&D DP1.2-Vision-Fiber · 50
Configuration
(default:
(default: