Specifications - Makita 4101RH Bedienungsanleitung

ENGLISH (Original instructions)
1-1. TEST button
1-2. RESET or "ON" button
1-3. Pilot lamp
1-4. Portable residual current device
(PRCD)
2-1. Wing bolt
2-2. Base
3-1. Wing nut
4-1. Wing bolt
4-2. End of blade case
4-3. Red line

SPECIFICATIONS

Max. cutting capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
The tool should be used on horizontal
surfaces.
･
Do not use the tool upside down.
･
The tool should be used with the PRCD
(Portable Residual Current Device).
･
Do not use the abrasive cut-off wheel.
･
After use, brush off accumulation of dust
on the base.
･
Do not use the saw blade.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
Explanation of general view
5-1. Base
5-2. Top guide
6-1. Switch trigger
6-2. Lock-off button
7-1. Wrench 22
7-2. Hex wrench
8-1. Inner flange
8-2. Diamond wheel
8-3. Outer flange
8-4. Hex socket head bolt
9-1. Wing bolt
Model
Wheel diameter
90°
45°
-1
)
Overall length
Net weight
Safety class
equipment
END104-3
Intended use
The tool is intended for cutting in brick, concrete and
stone with the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. This tool
should be grounded while in use to protect the operator
from electric shock. Use only three-wire extension cords
which have three-prong grounding-type plugs and
three-pole receptacles which accept the tool's plug.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
and its
3
9-2. Blade case
9-3. Water pipe
10-1. Clamp
10-2. Cover (A)
12-1. Clamp
12-2. Cover (A)
13-1. Cover (B)
13-2. Screw
14-1. Limit mark
15-1. Brush holder cap
15-2. Screwdriver
4101RH
125 mm
41.5 mm
26 mm
12,000
236 mm
3.0 kg
Class I
an environmentally compatible recycling
facility.
) : 101 dB(A)
pA
) : 112 dB(A)
WA
Wear ear protection
ENE023-1
ENF001-1
ENG905-1