Operation; Maintenance - Makita 4101RH Bedienungsanleitung

Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
Fig.6
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, push in the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing diamond wheel
Fig.7
Hold the outer flange with the wrench and loosen the hex
socket head bolt clockwise with the hex wrench. Then
remove the hex socket head bolt, outer flange and
diamond wheel.
Install the diamond wheel, outer flange and hex socket
head bolt onto the spindle. Hold the outer flange with the
wrench and tighten the hex socket head bolt
counterclockwise with the hex wrench. BE SURE TO
TIGHTEN THE HEX SOCKET HEAD BOLT SECURELY.
Fig.8
CAUTION:
Use only the Makita wrench to install or remove the
•
wheel.
Installing water pipe
Fig.9
First, unplug the tool. Loosen the wing bolt on the depth
guide and move the base down. Install the water pipe on
the blade case using the screw.
Attach the vinyl tube onto the water pipe and attach the
adapter on the vinyl tube to a faucet of water mains
pressure. Adjust the amount of water flow by simply
adjusting the water cock.
Installing cover (A)
Fig.10
Install the cover (A) on the tool so that its side with
"Upside " mark faces upward.

OPERATION

Fig.11
Adjust the amount of water flow. Hold the tool firmly. Set
the base plate on the workpiece to be cut without the
wheel making any contact. Then turn the tool on and wait
until the wheel attains full speed. Now simply move the
tool forward over the workpiece surface, keeping it flat
and advancing smoothly until the cutting is completed.
Keep your cutting line straight and your speed of
advance uniform.
CAUTION:
THIS TOOL SHOULD ONLY BE USED ON
•
HORIZONTAL SURFACES.
Be sure to move the tool forward in a straight line
•
and gently. Forcing and exerting excessive
pressure or allowing the wheel to bend, pinch or
twist in the cut can cause overheating of the motor
and dangerous kickback of the tool.
Since excessive cutting may cause overload of the
•
motor, the depth of cut should not be more than 20
mm at a pass. When you wish to cut more than 20
mm deep, make a couple of passes with
progressively deeper settings.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Dressing diamond wheel
If the cutting action of the diamond wheel begins to
diminish, use an old discarded coarse grit bench grinder
wheel or concrete block to dress the diamond wheel. To
do this, tightly secure the bench grinder wheel or
concrete block and cut in it.
After use
Blow away dust from the inside of the tool by running the
tool at an idle for a while. Brush off accumulation of dust
on the base. Accumulation of dust in the motor or on the
base may cause a malfunction of the tool.
Cleaning covers
Fig.12
When accumulation of dust on the cover (A) looks
excessive, loosen the clamp and remove the cover (A).
Wash off accumulation of dust inside the cover (A) and
wipe it. Then install the cover (A) on the tool so that its
side with "Upside
(A) toward the motor as far as it will go and secure it by
tightening the clamp.
7
" mark faces upward. Push the cover