Camera Recording; Insert The Sd Card - XciteRC Hubsan X4 FPV Bedienungsanleitung

www.hubsan.com
8.4.1 Left Flip
Push the Aileron stick fully to the right and then quickly push it fully to the left. Release the stick to
the center position after the ip.
MODE 2 MODE 1
8.4.2 Right Flip
Push the Aileron stick fully to the left and then quickly push it fully to the right. Release the stick to
the center after the ip.
MODE 2 MODE 1
8.4.3 Forward Flip
Pull the Elevator stick backward and then quickly push it forward. Release the stick to the center
after the ip.
MODE 2 MODE 1
18
H107D
THE HUBSAN X4

6 CAMERA RECORDING

Note:
Always turn OFF the power of the transmitter before inserting or removing the SD card.
Always stop the video recording function and power o the battery rstly, and then you
can take out the SD card.
WARNING! ALWAYS FORMAT AND ACTIVATE CAMERA RECORDING BEFORE FLIGHT!

6.1 Insert the SD card

Note:Carefully and properly orient the SD card
for insertion in the TX. (See the picture to the
right) Avoid removing the SD card and
re-inserting again too quickly otherwise the
recording module will not work properly
6.2 The screen will display REC in red and
blinking when recording is started.(See the right
picture)
6.3 Start/Stop recording using the remote.
WARNING! First activate the camera before
ight in order to make sure the SD card is
formatted. Formatting while in ight will result
in loss of control.
www.hubsan.com
0:08:49
REC
Press the button to
switch ON/OFF
video recording
11
H107D
THE HUBSAN X4