Advanced Performance Setup; Reversing Channel Setup; Led Indications - XciteRC Hubsan X4 FPV Bedienungsanleitung

www.hubsan.com

8 ADVANCED PERFORMANCE SETUP

8.1 Reversing channel setup

If you would like to reverse any of the stick functions due to personal preference then
follow the instructions below. Be aware that this will change the controls back to front.
Press down the ELEVATOR stick for 1 second to enter setting status, move the stick
up/down to choose SET REVERSE, push the ELEVATOR stick to the right, move it
up/down to choose and push right to confirm or exit. Hold down the ELEVATOR stick for
2 seconds to exit.
0:08:49
MAIN MENU
Play Record
Set Real Time
Format SD Card
Set Reverse
Set Sensitive
5.8G Frequence
8.2 SENSITIVITY SET UP
If you would like to change the sensitivity of any of the stick functions then follow
instructions below. A higher sensitivity value will enable larger/faster movement of the
aircraft,while a lower sensitivity value will enable smaller/slower movement.
Press down the ELEVATOR stick for 1 second to enter setting status, move the stick
up/down to choose SET SENSITIVE, push the ELEVATOR stick to the right, press the
elevator/ aileron/ rudder trim to set the sensitivity. Push the elevator stick to the right
to exit . Hold down the ELEVATOR stick for 2 seconds to exit the setup menu.
0:08:49
MAIN MENU
Play Record
Set Real Time
Format SD Card
Set Reverse
Set Sensitive
5.8G Frequence
16
H107D
THE HUBSAN X4
0:08:49
Set Reverse
Exit
Elevator Normal
Aileron Revers
Rudder Normal
0:08:49
Set Sensitive
Exit
Normal mode
Elevator : 50
Aileron : 50
Rudder : 50
7.1.4 Insert the battery into the bottom of your X4. Make sure the battery and wires are pushed
into the end of the battery compartment, so they will not negatively a ect the center of gravity
and cause unstable ight. Twist the wires and squeeze them into the notched holder as
shown, to prevent shaking when ying.
Always disconnect the X4 battery plug after turning o the transmitter when you stop ying.

7.1.5 LED Indications

After a "beep", the red LED on the transmitter turns green, and the 6 lights on the X4 light
steadily, indicating successful pairing. Press the lower throttle trim for about 2 seconds to turn
the LEDs on or o . NOTE: The LEDs will automatically blink when the quadcopter battery
power is low or the pairing has failed.
First Pilot View(FPV) Instructions:
For those just starting FPV with the Hubsan H107D please start S-L-O-W-L-Y and use the following
guidance:
1. Learn how to y the X4 and maintain control both indoors and outdoors at an altitude no higher
than 10 feet before you advance to FPV flight and higher altitudes. A large part of being successful
in FPV is training your fingers and brain to know how the model will respond with your inputs so
you can predetermine your stick movements. It is very di erent to look at an LCD or goggles and
www.hubsan.com
MODE 1 MODE 2
13
H107D
THE HUBSAN X4