Transmitter Battery Installation - XciteRC Hubsan X4 FPV Bedienungsanleitung

www.hubsan.com
5.2 Transmitter Stick Calibration
Mode 2: Push both sticks to the upper left position and hold, then power on the transmitter. Rotate
both sticks twice. Hold down any trim until the LED on the transmitter blinks red, indicating
successful calibration.
Mode 1: Push the left stick to the upper left position and right stick to the upper right position and
hold, then power on the transmitter. Rotate both sticks twice. Hold down any trim until the LED on
the transmitter blinks red, indicating successful calibration.

5.3 Transmitter Battery Installation

Notice: Do not mix old and new batteries.
Do not mix different types of batteries.
Do not charge non-rechargeable batteries.
PUSH
Install 4 x AA batteries
Remove the cover
according to the correct polarities
08
H107D
THE HUBSAN X4
Attention： After a crash landing, the protection cover will loose and block the
propellers, check and press back the four cover holes before ying again.
PUSH
Replace cover
www.hubsan.com
>2mm
21
H107D
THE HUBSAN X4