Camera Mount; The Remote Control System - XciteRC Runner 250 Bedienungsanleitung

Camera mount · The remote control system

Camera mount

Fit the mount using the supplied
screws.
Snap the frame closed around the
camera.

The remote control system

Here you get an overview of the remote control system of your XciteRC Runner 250 and its various features
and settings. Before the first flight, you should absolutely have read and understood all these functions and
settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter, therefore slide the cover
down (1). Insert four AA batteries into the battery compartment of the transmitter (2). Pay attention to the
correct polarity!
Battery compartment-
cover
1
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch.
• The red POWER LED must lit.
model may not started – crash hazard! Change transmitter batteries immediately.
• WARNING: check the POWER LED also during operation. If the POWER LED starts to blink, stop
operation, switch the model off and replace the transmitter batteries – crash hazard!
• ATTENTION: The maximum range of the remote control system is about 600 meters. This model
is equipped with an Coming Home function and comes automatically back to the starting point after
exceeding the maximum range. This works only if a sufficient GPS signal was present at the start - read
the section LEDs and their meaning.
XciteRC Runner 250
Install the rubber isolated camera
mount.
Re-fit the frame to the rubber
isolated mount.
4x 1.5 V AA
2
batteries
Attention: if the POWER LED flashes or does not light at all, the
Remove the thumbscrews
release the camera frame.
Alternatively, mount an action
camera in its own hardcase.
EN
to
25