Applying The Camera (Optional); Illumination; Landing; Maintenance - XciteRC 15002110 Bedienungsanleitung

EN

Applying the camera (optional)

Make sure that the SD card is inserted in the camera. Otherwise the the camera is deactivated. Each tome
pressing the Photo button makes a photo frame, accompanied by a short beep. Press the Video button, the
video recording starts, also the camera icon appears in the display, accompanied by a Di-Di sound and the
camera symbol in the display. Press the Video button again to stop the recording.
Photo button

Illumination

Press the control lever to switch the lighting of the Rocket 260 3D on or off. Is the lighting on, a bulb appears
in the transmitter sreen.

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the Quadrocopter.
• NOTE: if the flight battery runs empty, the Quadrocopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the Quadrocopter and then the transmitter.
WARNiNG: the motor of the XciteRC Rocket 260 3D may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage. Fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
22
Press
1
Video button
ON: Video recording
OFF: Video recording stopped
1
LCD Display
L . H
Camera · Illumination · Landing · Maintenance
LCD Display
L . H
%
E A S Y
2
%
E A S Y
2
XciteRC Rocket 260 3D