Training Of The Operator; Technical Data - Scheppach kw 7.0 Originalanleitung

Attention: risk of accident!
The wood must always be seated on both sides of the saw blade on the v-block of the rocker. (see arrows)
Caution Danger of accidents!
Wear safety shoes.
Accident risk!
Before commissioning instruction
manual read.

5. Training of the operator

• Forward the safety instructions to all people working on or with this machine.
• The minimum age for the operating person is 18 years. Trainees should be minimum 16 years of age, but are only
allowed to work with the machine under supervision.
• People running the machine should not be distracted.
• Keep children away from the to the net connected machine.
• Wear tight fitting clothes. Take off jewelry, rings and wristwatches.
• Observe all safety and hazard warnings on the machine and keep it in readable condition.
• Be careful at work: Danger of damaging finger(s) and hand(s) by the rotating cutting tool.
• Regular pauses must be observed during operation.
• Safety shoes and protective clothing must be worn during operation.

6. Technical Data

Article Number
Construction measurements:
Total length
Total width
Total height
Rocker support
Saw blade ø
Idle speed motor
Cutting speed saw blade
Weight
Power unit
Motor
Input power P1
24 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
kw 7.0
1905115902
mm 1060
mm 820
mm
mm
mm
1/min 1380
m/sec 51
kg 152
V/Hz 380 - 420 / 50
kW 5,2
Caution Danger of accidents!
To wear ear protection.
Wear safety glasses.
Attention!
Tool continues to run after
power disconnected!
Before any maintenance, cleaning
or repair work, disconnect the unit
from the power supply!
During Cardan shaft operation,
park the tractor and remove the
ignition key!
kwz 7.0
1905115903 1905115904
1410
900
1150
735
700
1400 -
51 51
156 171
380 - 420 / 50 Cardan shaft
7,5 -
kw-ze 7.0
1905115905
1500
900
1380
51
217
380 - 420 / 50
Cardan shaft
5,2