Handling The Protection Cage; Sawing Operation - Scheppach kw 7.0 Originalanleitung

Cut off the cable ties on the tension springs. Open the protective cover (1) and mount the tension springs as displayed in
the image.

14. Handling the protection cage

• Open the protective cover (1).
• Insert the material to be cut.
• Close the protective cover (1).
• Swivel the rocking frame (2) with hand grip (A) or (B) to the saw blade and saw through the material to be cut.
• Swivel the rocking frame (2) back and open the protective cover.
• Add more material to be cut and close the protective cover again.
1
2

15. Sawing operation

1 After the machine has been switched on, wait until the saw blade has reached full speed.
2 Put the wood on the rocker.
3 Take hold of both handle bars of the rocker with both hands and lead it evenly to the saw blade; thus the saw blade
is revealed.
4 Push the rocker evenly to ensure the engine speed does not drop.
5 Remove the wood from the rocker after it has returned to the initial position and the saw blade is covered. Then
place the next workpiece.
m Attention!
• Do not leave the machine unattended during operation.
• Switch the machine off and remove the mains plug or take out the ignition key when stopping work.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
B
A
2
1
GB 29