Electrical Connections - Carrier AquaSnap Plus 30AWH006H Installationsanleitung

Safety procedures
Units installation
The installation must be carried out by a qualified
installer.
DO NOT INSTALL IN A PLACE...

Electrical connections

All field electrical connections are the responsibility of
the installer.
DANGER
or death. These operations are carried out by
qualified personnel only.
WARNING
electromagnetic compatibility (2004/108/EC) and pressure
equipment (EEC/97/23) Directives.
followed for the main supply circuit.
in place.
be adequate to operate any other possible appliances
connected to the same line.
conformance with the unit power input indicated in the
rating plate of the unit.
switches are installed.
allow full disconnection under the conditions provided for
by overvoltage class III.
CAUTION
cable is connected in a wrong way, electric parts may be
damaged.
OUTDOOR UNIT
CHOOSE A PLACE...
weight and minimize vibration transmission.
Fix the unit with locally purchased bolts buried in the
block.
If the unit is installed in areas where heavy snowfalls
may occur, it is necessary to raise its level at least 200
mm above the usual snow level or alternatively to use
the outdoor unit bracket kit.
the cable must only be replaced by the technical support
in order to prevent any risk.
WARNING
may cause electric shock.
lightning rods or ground wires for telephone cables.
DANGER:
Do not modify this unit by removing any of the safety
guards or by by-passing any of the safety interlock switches.
FINAL CHECK
WARNING
generated.
events takes place:
30AW 3