Preparing For Use / Use; Use - LIVARNO LUX Z30503 Bedienungsanleitung

Preparing for use / Use

Note: The product is fitted with an overcharge protection circuit. In
spite of this, you should disconnect the light from the power supply after
the charging process is complete.
©
½
14 GB/IE
56632_livx_LED-Arbeitsleuchte_Content_LB3.indd 14
ATTENTION! When charging from a cigarette lighter socket, make
sure that the cigarette lighter socket adapter
serted into your vehicle's cigarette lighter socket. Failure to observe
this advice may result in overheating and consequent risk of fire.
Insert the mains adapter
rette lighter socket adapter
your vehicle. The charging indicator
the battery is being charged. The battery is fully charged as soon
as the charging indicator

Use

When using the light in a vehicle make sure that you do not endanger
the driver or the passengers. Store and secure the light in such a
way that, even under conditions of full braking, there is no danger
of damage to the product or personal injury.
Never point the LED beam on reflective areas, people or
animals. This can blind or irritate people and animals.
Even a LED beam of low power can cause damage to
the eye.
Note: The product has a hanger
the light. To do this, fold out the hanger
Do not pull on the light when it is hanging from the hook. The
hook could be torn out and the light damaged.
Note: The light also has a magnet
the light to magnetic surfaces (see Fig. D). Make sure that the light
is not struck or knocked while it is attached to a magnetic surface.
13
into a mains socket or insert the ciga-
14
into the cigarette lighter socket in
13
lights up red to show that
9
lights up green
9
, which can be used to suspend
2
upwards (see Fig. C).
2
, which can be used to attach
5
is always fully in-
29.12.10 13:17