Charging The Internal Battery - Silvercrest SLTR 70 A1 Schnellstartanleitung

NOTE
► Check the package for completeness and signs of visible damage .
► If the delivery is incomplete or damage has occurred as a result of defec-
tive packaging or during transport, contact the service hotline (see section
Service) .

Charging the internal battery

CAUTION
► Charge the internal battery only in dry indoor spaces .
NOTE
► Before using the device, the integrated battery must be completely
charged .
♦ Ensure that the device is switched off . When the device is switched on, the
red LED
8
button
the
♦ Connect the USB type A plug of the USB charging cable
power supply (5 V, at least 1500 mA) or a USB 3 .0 port (can be rec-
ognised by the blue USB socket) on your computer .
♦ Connect the micro USB plug of the USB charging cable
USB charging socket (DC 5V )
NOTE
► The device can also be charged during music playback . However, this
increases the charging time .
► The red LED
charged, the red LED
► Charging takes about 4 hours at a charging current of 1500 mA . When
the battery is fully charged, you can play back music for about 5 hours
at a medium volume . The playback time may vary depending on usage
(volume/mode) .
► When the battery is dead, you will hear beeps every few seconds and the
red LED
8
speaker switches off automatically .
SLTR 70 A1 / SLTE 70 A1
and the blue LED
for about 2 seconds .
5
lights up during charging . When the battery is fully
8
switches off .
8
will flash . When the battery performance drops too low, the
flash . To turn off the device, hold down
9
on the device .
7
to a USB
0
to the micro
0
GB │ IE │
25 ■