Stuart SBS40 Bedienungsanweisung Seite 6

5.6 Draining the bath
To empty the bath, ensure that the water has
cooled to below 60°C. The drain tap is located
at the rear of the bath (see figure 1). Attach a
suitable pipe to the drain tap and place the end
of the pipe over a drain or container. Turn the
drain tap anticlockwise to empty the bath.
When the bath is empty ensure that the drain
tap is closed.
NB Do NOT attempt to move or empty the
bath with hot water
6. Maintenance, Servicing
& Repair
WARNING: Ensure the unit is disconnected
from the mains electricity supply before
attempting maintenance or servicing.
This range of equipment does not require
routine servicing. The only maintenance required
is to clean external surfaces with a damp cloth
and mild detergent. Spillages or splashes should
be cleaned up straightaway after isolating the
unit from the mains electricity supply.
6.1 Repairs
Any repairs or replacement of parts MUST be
undertaken by suitably qualified personnel.
Only spare parts supplied or specified by
Barloworld Scientific Ltd. or its agent should
be used. Fitting of non-approved parts may
affect the performance of the safety
features designed into the instrument.
For a comprehensive list of parts required by
service engineers conducting internal repairs, or
to receive a service manual, please contact the
Sales Department of Barloworld Scientific Ltd
quoting both the model and serial number.
If in any doubt please contact the Technical
Department of Barloworld Scientific Ltd.
4
6.2 Cleaning
Periodically clean the bath with a damp cloth
and if necessary a mild detergent solution.
Do not use harsh or abrasive cleaning agents.
De-scaling may be required depending on the
hardness of the water.
If the bath is to be left unused for more than a
couple of days, drain the bath to prevent build
up of unwanted scale.
Accessories
The following range of accessories is available:
SBS40/1 Platform, linear shaking action
SBS40/2 Platform, orbital shaking action
SBS40/3 Platform, perforated
SBS40/4 Polycarbonate cover, hinged
SWB/1 Stainless steel cover
SBS40/5 Test tube rack, 143 x 1.5ml micro tubes
SBS40/6 Test tube rack, 120 x 13mm culture tubes
SBS40/7 Test tube rack, 72 x 16mm culture tubes
SBS40/8 Test tube rack, 56 x 15ml centrifuge tubes
SBS40/9 Test tube rack, 30 x 26mm culture tubes
SBS40/10 Test tube rack, 25 x 50ml centrifuge tubes
SBS30/1 Spare springs (pack of 10)
The perforated platform (SBS40/3) is available to
convert the SBS40 shaking water bath to an unstirred
bath.
A choice of stainless steel (SWB/1) or polycarbonate
gabled cover(SBS40/4) is also available. The SBS40
has hinge points at either side enabling the
polycarbonate cover to be hinged on preference.
6.4 Technical Specification
Capacity
Temperature range
Temperature stability
Shaking speed
Shaking orbit/amplitude
Internal dimensions (w x d x h)
Overall dimensions (w x d x h)
Net weight
Electrical supply
24L
Ambient +5°C to 99.9°C
±0.25°C
20-200rpm
20mm
300 x 500 x 200 mm
335 x 580 x 330 mm
17kg
230V, 50hz 1400W