Heyner capsula MT5 Bedienungsanleitung Seite 5

English
Index / page
1. Using the as a child car seat
capsula® MT5
2. GROUP II+III (about 15 to 36 kg)
3. Care Instructions
4. Important Notices
5. Some final fints
Operating Instructions
A Connecting hooks
B Fitting holes
C Fixation lugs for three-point belt
D Headrest
E Belt guide
N Diagonal belt of the three-point-
vehicle-belt
c
5
O Lap belt of the three-point-
vehicle-belt
P Belt latch of the three-point-
vehicle-belt
Q Belt buckle of the three-point-
vehicle-belt
Z Head rest de-block lever
-capsula.com
1. Using the
capsula® MT5
S. 6
You have purchased the
capsula® MT5
S. 6
that the optimum safety characteristics can only be achieved if the seat is used properly according to instructions.
S. 8
Therefore we ask you to ensure the correct installation of the seat in your vehicle by reading the operating
S. 8
instructions carefully. Please keep instructions always with the seat for further information.
Only to be assembled by adults!
S. 9
Attention:
Only use the capsula® MT5 backrest in combination with the
must not be used alone, as it doesn't guarantee any safety. To get maximum side protection in an accident,
use the backrest for Group II+III consistently.
Warning:
Do not use without backrest. In that case, the child can not get enough side protection
capsula® MT5
in an accident.
2. GROUP II+III (about 15 to 36 kg)
2.1. Connecting the backrest to the booster seat (fig.1-3) (just if non-assembled)
If backrest (fig.1) and booster (fig.2) are delivered in a non-assembled way, please follow these instructions
to connect both together before using it for children in group II.
Lay down the booster (fig.2) on the floor and the backrest (fig.1) flat right behind. Then thread the connecting
hooks (A) on the bottom of the backrest into the fitting holes (B) on the back of the booster with a firm down-
wards motion. Now bring the backrest slowly upright, 90°to the booster.
The connecting hooks should now slip into the fitting holes with an audible sound. As the result the backrest
should be well fixed to the booster in the upright position. It must not slip away now. Otherwise you may not
have fixed it very well an using it would be dangerous. In this case please repeat the first steps of this part of
the instruction.
as a child car seat
car seat for your child. We thank you for your trust. Please note,
capsula® MT5 booster. The backrest
c -capsula.com
English
GB GB
6