Installation And Commissioning; Operating Levels Of The Device - bürkert 8025 Kurzanleitung

Type 8025/8035 /

Installation and commissioning

9. insTAllATion AnD
commissioninG
9.1. safety instructions
Warning
risk of injury due to non-conforming operating.
Non-conforming operating could lead to injuries and damage the
device and its surroundings.
• The operators in charge of operating must have read and under-
stood the contents of this manual.
• In particular, observe the safety recommendations and intended use.
• The device/installation must only be operated by suitably trained
staff.
Warning
danger due to non-conforming commissioning.
Non-conforming commissioning could lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
• In particular, observe the safety recommendations and intended use.
• The device / the installation must only be commissioned by suit-
ably trained staff.
• Before commissioning, set the K Factor of the fitting used. See
chap. "9.6".
9.2.

operating levels of the device

The device has two operating levels: the Process level and the Con-
figuration level.
Table 4: Default settings of the device
function
LANGUAGE
UNIT of the flow rate
UNIT of the totalizers
Number of decimal positions 1
4 mA current output
20 mA current output
K FACTOR
FILTER
Value of a pulse (PU)
Unit of the pulse output
Relay 1-
Relay 1+
Relay 1 inverted
Relay 2-
Relay 2+
Relay 2 inverted
English
default value
English
L/min, 1 decimal
L
0.000
100.0
51.20
5
00.05
L
40.0
50.0
no
80.0
90.0
no
49