Battery; Recharging The Battery - Medion MD 80686 Anleitung

DVD-Porty MD 80686 D EN.book Seite 11 Montag, 30. Mai 2005 4:05 16

Battery

1 DC IN socket
2 Screw button: Turn this button to fix the
battery to the main device via the screw,
and to loosen it.
3 LED Charge indicator;
LED off: Battery is empty;
LED red: Battery is being charged;
LED green: Charging has ended.
4 Clips for power input to the DVD player.
Important information
Please adhere to the special safety advice for the battery at the start of these
instructions!
Charge the battery fully before using it for the first time.
Both the battery and main device heat up during use. This is not a defect.
If the device is on battery power and the player is left switched on for 10 minutes
but is not in use, the device will switch itself off (Auto Power Off).
Operation may become unstable if the DVD player is switched on but the battery
is not fully charged. Ensure that the battery is fully charged if you want to use it.

Recharging the battery

Notes on charging
If the battery is warm before charging, it may take longer to charge than normal. It
may not charge properly. Allow the battery to cool down first.
The battery should not be charged in a very hot location; there is a risk of ex-
plosion!
Charging normally takes 4 to 5 hours.
Stop charging as soon as the battery is full.
The battery supplies power for around 3 hours of continuous operation.
Charging
You can charge the battery separately or while it is connected to the device. This is
done as follows:
• If necessary detach the battery from the main device.
EN
EN-11