Touch Sensor; Ironing With Steam Blast; Putting The Steam Iron Down; After Use - Silvercrest SDBS 2800 A1 Bedienungsanleitung

Touch sensor (

The touch sensor in the handle allows the iron to
'recognise' whether you are holding it in your hand.
■ If the temperature control
setting range and a steam level is selected,
steam will be produced as long as your hand is
in contact with the touch sensor field
■ If there is no contact with the touch sensor
field , the iron will stop producing steam.
■ As soon as you pick up the iron again, steam
production will be resumed.

Ironing with steam blast

The steam blast function is especially suitable for
smoothing difficult-to-reach parts of a garment.
■ Raise the steam iron slightly.
■ For a steam blast, press the steam blast button
.
You can also use the steam blast
( ) function to
smooth hanging textiles.
■ Hold the iron vertically and press the steam
blast button
■ 20
│ GB│IE
)
is set in the red
.
.

Putting the steam iron down

RISK OF FIRE!
► Never leave a hot steam iron unattended if
it is switched on or connected to the mains
power supply.
■ Stand the steam iron only on its base

After use

■ Remove the power plug from the mains power
socket.
■ Empty the water tank and clean the sole of the
iron .
■ Place the cooled-down steam iron on its base

Drip-Stop function

With conventional steam irons, water can drip from
the sole of the iron
iron however possesses a new feature, the DRIP-
STOP function (
the iron automatically switches off the steam-blast
function.
Then set a suitable temperature with the tempera-
ture control . As soon as this is reached, steam
production is resumed.

Automatic descaling function

( )
There is a descaling cartridge in the water tank that
helps reduce the build-up of limescale.
This descaling cartridge is a permanent fixture in
the water tank and cannot be replaced.
.
at low temperatures. This
). At low temperatures
SDBS 2800 A1
.