Prepare Aerial Cable - Medion MD 24285 Anleitung

Prepare aerial cable.

Warning!
The wire mesh and internal lead (core) conduct electricity! No
part of the protective mesh may come into contact with the
internal lead when assembling the F-plug as this could cause
a short circuit.
The supplied aerial cable may be shortened depending on the distance
between the aerial and the receiver. The following steps describe fixing the
F plug to the aerial cable.
Take the aerial cable with the end without the F plug and shorten it to the
required length.
Note
Ensure that both connections for the "F" connectors on the LNB
converter protect against moisture with the enclosed rubber grommets.
Insert both grommets!
Remove the outer, white insulation over a length
of around 20 millimetres.
Remove the inner wire protection over a length
of around 10 millimetres. Ensure that the
internal lead is not damaged.
The internal lead is revealed over a length of 10
millimetres.
Now twist the F plug supplied onto the aerial
cable until the wire protection is completely
covered by the plug.
Shorten the inner lead such that this stands out
over the F plug's final edge by around 2
millimetres.
13