Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Installationshandbuch Seite 2

6. Installation Procedures
6
S-module
[Fig. 6.0.1]
[Fig. 6.0.2]
B
A
<A>
[Fig. 6.0.3]
C
<B>
[Fig. 6.0.4]
2
<B>
<A> Remove the front panel from the unit by unscrewing the eight screws.
<B> Remove the fan guard by unscrewing the six screws.
* Remove the snow protection hood (optional parts), if any.
<A>
A
<A>
<A> Remove the top attachment and the bottom attachment connecting
<B> Remove the cover from main control box by unscrewing the three
B D
<A>
B
<B>
<A> Cut the two cable ties holding the weak electrical wiring inside the main control box
in place.
<B> Loosen the four cable straps holding the weak and strong electrical wirings.
<C> Cut the two cable ties holding the rubber bush at the bottom of the main control box.
A
<A>
A Cable tie
B Cable strap
B
<B>
A
<C>
6.0
B
<B>
A
<A> Remove the drain pan cover by unscrewing the screws and
cutting the cable tie.
<B> Remove the front drain pan by unscrewing the two screws.
Be sure to remove the two rod holders holding the check
joints to the drain pan.
A Drain pan cover
B Drain pan
C Rod holder
the main control box and inverter control box by unscrewing the two
screws.
screws.
A Top attachment
B Bottom attachment
C Main control box
D Inverter control box
C <B>