Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Installationshandbuch Seite 19

9. Terminal Assy Installation
Step 1. Installing and wiring the terminal block to the control box
9
S-module
[Fig. 9.1.0.1]
C
D
<B>
<A> Remove the attachment plate from the inverter control box by unscrewing the four screws.
<B> Loosen the cable strap holding the fan motor electrical wiring.
<C> Mount the terminal assy on the inverter control box with four screws.
<D> Thread the terminal assy wiring through the rubber bush.
A Inverter control box
B Attachment plate
C Fan motor electrical wiring
D Cable strap
E Terminal assy
[Fig. 9.1.0.2]
<A>
<B>
9.1.0
A
<A>
<A>
B
<A> Fasten the terminal assy wiring with a wire saddle.
A
<B> Thread the terminal assy wiring through the rubber bush on the main control box
on the strong electrical wiring side.
<C> Connect the wiring to the circuit board.
<D> Fasten excess wiring with the cable strap.
A Fuse wiring
B Fuse wiring connector
C Cable strap
<C>
C
<D>
<C>
E
<D>
B
<C>
19